topic Re: Nest thermostat keeps saying Please remove the thermostat from base then reattach, but won’t ... in Nest Thermostats

Nest thermostat keeps saying Please remove the thermostat from base then reattach, but won’t restart

Tigerblue — Mon, 03 Oct 2022 23:26:48 GMT

Nest thermostat keeps saying Please remove the thermostat from base then reattach, but won’t restart

Re: Nest thermostat keeps saying Please remove the thermostat from base then reattach, but won’t res

Flores922 — Tue, 04 Oct 2022 12:12:35 GMT

I’m having the same issues and all the wires are pushed back, it had stated low battery and I charged it overnight but still not connecting.

Re: Nest thermostat keeps saying Please remove the thermostat from base then reattach, but won’t ...

EdwardT — Fri, 07 Oct 2022 16:24:23 GMT

Hi Flores922,

Thanks for reaching out. I'm sorry to hear that you're having an issue with your Nest Thermostat. Please try the steps below to isolate the issue.

Check the Nest thermostat from the side. If the white plastic from the thermostat base is visible around any of the edges, the Nest display isn't seated properly. In this case, reseat the display.
If the display doesn’t go any further, please detach it from the base and check for loose wires or other obstructions that could cause the display to push away the base.
Inspect the 20-pin connector for any visible damage. Check both the male and female ends on the base and display.

Looking forward to your response.

Thanks,

Edward

Re: Nest thermostat keeps saying Please remove the thermostat from base then reattach, but won’t ...

Jake — Tue, 11 Oct 2022 17:01:27 GMT

Hey all,

I wanted to check in and see if you managed to see Edward's post. Please let me know if you have any questions from here. I would be happy to assist, and make sure you are good to go.

Best regards,
Jake

Re: Nest thermostat keeps saying Please remove the thermostat from base then reattach, but won’t ...

Jake — Wed, 12 Oct 2022 16:20:32 GMT

Hey all,

I wanted to check in, and let you know that I will be locking the thread in 24 hours.

Best regards,

Jake