cancel
Showing results for 
Search instead for 
Did you mean: 
Replies are disabled for this topic. Start a new one or visit our Help Center.

Nest (2020) Thermostat Wiring/Setup Support

ccrg75
Community Member

I recently purchased a Nest (2020) thermostat for my condo. My condo (which is new) uses baseboard radiators (central boiler) for heat and has no air conditioning. The previous wire configuration utilized the Y and R wires, with the common wire unused (inside the wall).

After completing the setup, I realize the unit considers this a cooling only setup (due to the Y wire). Which doesn’t function correctly. I assume the previous wire configuration on the basic thermostat was incorrect and that the Y wire is in fact the W wire.

Therefore, I switched the Y and W, factory reset the Nest, and setup using W,R, and C. Unfortunately, upon placing the Nest onto the base during that setup step, it won’t connect to the Nest app to complete the setup.

Note, if I remove the Nest from the base on the wall during setup, it will connect to the app, but as soon as you replace it on the base it disconnects and will not connect to the app.

Any thoughts/suggestions for this issue?

3 REPLIES 3

Jake
Community Specialist
Community Specialist

Hey ccrg75,

 

Sorry for the late reply. I wanted to follow up and ensure you are good to go. Please let me know if you are still having any trouble from here, as I would be happy to take a closer look and assist you further. 

Best regards,
Jake

Jake
Community Specialist
Community Specialist

Hey ccrg75,

 

I want to ensure you are good to go, and everything is working properly. Please let me know if you are still having trouble, as I will be locking the thread in 24 hours due to inactivity. 

Best regards,
Jake

Jake
Community Specialist
Community Specialist

Hey ccrg75,

 

It has been a few days since the last reply, and I am going to lock the thread at this time. If you have any questions, please feel free to create a new post. 

Best regards,
Jake