Temperature shown on the display.

[Gioweb]

Hallo,

I'm using this Thermostat since 2020 and I asked for a solution, but no way.

Now I try again and I hope someone can help me.

I would like to know if there's a the possibility to show decimal points with higher resolution on the display (actually I can move temperature set with a step of 0,5°C).

And I would like to see the room temperature bigger on the display (it's very difficult to see the real temperature) and with a bigger resolution.

To do that you need to go to: settings, sensors and than you can see the real temperature.

It's not useful, too complex...

An higher resolution will help also for the consumptions.

Another thing would be the possibility to set the hysteresis between the switch ON and OFF.

I have a PELLET BOILER, so switching on and off will increase the consumption.

I'm not english, I'm sorry if my English would be not really comprehensive, but I hope someone can understand and help me.

[Gioweb]

UP...

Is there someone that can help me?

[AlexD]

Thanks for your question @Gioweb and sorry for the late reply.

The temperature adjustment can only be done in 0.5 degree increments currently. And you will see the rounded temperature in the app and on the display. To see the exact temperature you have to go to Settings> Technical info> Sensors, as you mentioned. That is currently the only location where you can see the precise unrounded temperature.  

[Gioweb]

Thanks for your reply.

I know I can see the exact temperature in the Technical Info, but it doesn't solve the problem.

Using 0.5°C resolution, the consumption IS HIGHER, and without the opportunity to set the Hysteresis manually it can happen to damage the equipment.

So, this application and this device is not really developed and it's not really useful.

Also the LED in the remote device (the one connected to the boiler) could change color so you can understand if it's running or not.

Please, work around this device, it COULD be the top device, actually is useful at 30%...

Believe in me.

But, by the way, thanks for your kind reply.

[AlexD]

Thank you for all the feedback. You make some very good points. We're always looking for ways to improve both our products and services. Should there be any update rest assured that we'll let everyone know on our official channels. 

[Gioweb]

Oh, well AlexD,

Thanks to you, for your kind replies!

I really hope that there will be some improvements, than it will become a really good device.

SO:

1. Better resolution for the indicated temperature (not 0,5°C, but 0.1°C would be better).
2. Better visualization of the temperature in the local display and in the APP (because it's really difficult to understand immediately the real temperature).
3. Set of the Hysteresis manually (sometimes the boiler will start and stop several times so it can be damaged and also increases the consumption, expecially for the Pellet boiler).
4. The possibility to see LED changes in the remote device, so you can see if the Thermostat has sent the command or not).

I hope this summary would be useful and I hope you can apply those changes too.

Thanks in advance and best regards.

[CristianC]

Hey @Gioweb. Thanks for your feedback.