06-26-2022 03:41 PM
I obviously have a 7 wire system.
Orange wire -> O/W2*
Yellow wire -> Y1
Red Wire -> R
Green Wire -> G
Blue Wire -> C
White (AND what looks like a brown or faded black) wire -> W/W1
Since I have 2 wires going to W/W1 how do I split them up in the next? Where does white go? Where does Brown (or possibly faded black) go?
All the other wires seem really straightforward
06-26-2022 03:50 PM
Better image...
06-26-2022 05:01 PM
Sorry to hijack your post here. I'm just wanting in on the conversation. I, too, am experiencing install issues. Like you, I tried to follow the step by steps. I got all hooked up, things seemed fine, set the temp and shazam, the air conditioner kicked right on. "Life is great",I thought. In a few minutes, I found that it was blowing hot air.
Like you, I had a confusion about that jumper wire that tied 2 posts together on my last thermostat. There WAS a step in the instructions, before labeling all of the wires, that said "remove" such a bridge. I thought that it would be not necessary on the nest.
06-26-2022 05:02 PM
07-02-2022 02:43 PM
Hi folks,
Thanks for reaching out. I'm sorry to hear that you're having issues with wiring your Nest Thermostat. @michaelcarter72, could you check the control board of your HVAC system to see where the other end of the wires are connected to? @Stacik73, how's your Nest Thermostat wired?
Looking forward to your response.
Thanks,
Edward
07-05-2022 02:52 PM
Hi folks,
It's me again. I wanted to check back in to see if you have other questions and concerns. Feel free to let me know if you do.
Thanks,
Edward
07-06-2022 03:10 PM
Hi folks,
Just checking in to make sure that you've seen our response. Please let us know if you have any other questions or concerns as I will be locking this in 24 hours.
Thanks,
Edward