cancel
Showing results for 
Search instead for 
Did you mean: 
Replies are disabled for this topic. Start a new one or visit our Help Center.

am in UK and and struggling to pair Nest thermostat E with heat link. End up getting TH026 (4050)

Pankaj
Community Member

Hi , I recently purchased Nest thermostat E and started to pair. I end up getting TH026 (4050) error on nest app.

 

I tried to reset heat link multiple times by pressing heat link button for 20 sec. Still not able to pair.

 

Please  help as this is unusable 

6 REPLIES 6

Pankaj
Community Member

Do I need to wire heat link first as I am pairing before wiring ?

pra_19_343
Community Member

1. Reset the Heat Link E. 2. Press on the button that says Nest and hold it until the LED goes from green to blank (off) to pulsing blue to solid yellow. a. Once the light is solid yellow, release the button, and in a few seconds, the pairing light will slowly pulse. (This time, the light should stay on longer and not go out in 5 seconds.) b. Add the Heat Link E again. Once it's connected, the thermostat should continue the setup. 3. Enter the room name, schedule, and Eco temperature. 4. Test the thermostat. 5. Tap Finish.

pra_19_343
Community Member

I am facing the same problem, the issue was solved after following the above steps.

CristianC
Community Specialist
Community Specialist

Hey @Pankaj,

 

Thanks for reaching out. I'd love to help. Did you try the steps posted by pra_19_343?

CristianC
Community Specialist
Community Specialist

Hello again. Just checking in. Still need my help?

AlexD
Community Specialist
Community Specialist

Hi. I will go ahead and lock this thread since there have not been any replies. 

 

If anything else come that we can assist with, make sure to reach out to us on any of our support channels. 

 

Best regards,

AlexD