11-14-2022 07:27 PM
I have a heat 1 and a heat 2 and the heat 2 starts and stops after a couple seconds and just repeats , I can’t turn the heat up more than 2 degrees before it goes into heat 2 mode and like I said it just keeps starting and stopping , but the wiring shows it was correct
11-18-2022 07:00 PM
Hi Natedog4213,
Thanks for reaching out. I'm sorry to hear that you're having an issue with your Nest Thermostat. I'd love to know more about this and I have a few questions:
Looking forward to your response.
Thanks,
Edward
11-21-2022 07:05 PM
Hey Natedog4213,
It's me again. I wanted to check back in to see if you have other questions and concerns. Feel free to let me know if you do.
Thanks,
Edward
11-22-2022 07:41 PM
Hi Natedog4213,
I'm just checking in to make sure that you've seen our response. Please let us know if you have any other questions or concerns as I will be locking this in 24 hours.
Thanks,
Edward
11-23-2022 07:30 AM
I have the 3rd generation learning and I it says there is power but not enough
11-23-2022 10:45 AM
Hi folks,
I wanted to stop by and see how I could help.
Thanks for assisting, Edward.
@Natedog4213, it appears that your system short cycles and switches to 2-stage heating to meet its demand due to a power issue. Let's sort this out.
To isolate: could you tell which wiring connection your thermostat has? Is this a first-time installation? Also, please check the power readouts from the thermostat settings under "technical info."
I'll wait for your response.
Best regards,
Mark
11-26-2022 02:59 PM
Hi Natedog4213,
Checking back in — how's it going? Still need our help? Let us know so we can assist you right away.
Thanks,
Mark
12-01-2022 11:09 AM
Hey there,
I wanted to check in, and let you know that I will be locking the thread in 24 hours.
Best regards,
Jake