Are you a homeowner and you are selling your home and leaving your Google Nest Thermostat for the new owner? What do you need to do to make the transfer painless for you and the new owner? First and foremost, DO NOT PERFORM A FACTORY RESET. The Googl...
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
cannot access thermostat since the email attached is no longer valid
I am trying to install a Google Nest Gen 4, and my old thermostat had two jumpers1. Between Rh and Rc2. Between Y and WI also have no O wire. The only wires I have are:1. C wire2. Rh/Rc jumped wire3. G wire4. Y/W jumped wireI’m also only measuring 13...
I forgot my pin at nest thermostat now i am not able to factory reset neither do nothing without the pin and i dont have access to nest app as well
I was seeking confirmation if my wiring diagram would be correct for a gen 4 thermostat on my duel fuel unit. My unit consists of a primary heat pump then the break point is set to *36 degrees and kicks on propane furnace. I have noticed sometimes wh...
I have a 3rd generation Nest thermostat. My current temp is 70 degrees. I turned it up to 72 and it says "in 30 minutes". Why is this happening? It should start to heat up right away.Jody
Does anyone know how to keep the fan on using a NEST 4G Fan even while not calling for AC or Heat without having to reset it every week or another time interval?
Can a Nest thermostat handle a single pole double pole situation? I have an older hot water system that needs a signal to open the valve and close the valve.
Program issues on my nest thermostat
I once connected a Nest smart thermostat to a gas fired boiler by running a new 5 (?) strand wire from the T-stat to the boiler and attaching all the colored wires in the corresponding colored slots. Easy!Now in a different house I want to do the sam...
Has anyone installed a 3rd generation with three wires red, white and black. If so, what are you connecting these wires too on the base? Pics would help.
