Google Nest Community

Marksas · 11-29-2022

Hello, i have an older Airco forced hot air furnace that uses a Becket oil burner and Honeywell R8184G 1302 Oil Primary Control. I am at a loss as to where to install the power connector to use with our new Learning Tstat. There really is not 'circui...

Marksas · 12-08-2022

Nope, I'm all set! Thank you

Marksas · 11-30-2022

Great thanks, this will help.

Marksas · 11-30-2022

Thank you so much, my local HD sells 50' of 18/5 for $23, that should do the trick. The only thing i still need to figure out is the switch mounted to the outside of the furnace that turns on/off the thermostat. You can see in my first photo wires ru...

Marksas · 11-30-2022

Ok, i was confused because I thought the bottom 2 F's were only for CAD Cell wires, but you think based on the wiring diagram that the bottom F is also the Common? If using the 5 conductor wire as you mentioned, what would the wiring look like at the...

Marksas · 11-30-2022

I was actually thinking of using a separate 24v transformer with 2 wires for power (C & one of the R’s) and use the existing 2 thermostat wires, W1 & Rc?

Google Nest Community

User Statistics

User Activity

Help installing power connector to older forced hot air oiler burner

Re: Help installing power connector to older forced hot air oiler burner

Re: Help installing power connector to older forced hot air oiler burner

Re: Help installing power connector to older forced hot air oiler burner

Re: Help installing power connector to older forced hot air oiler burner

Re: Help installing power connector to older forced hot air oiler burner