Nest learning thermostat V3 installation issues

[Giftedbryan]

Hello everyone!

I recently purchased a pre-loved Nest Learning Thermostat V3 and installed it into my home. I used the OT1 and OT2 wires to go to my boiler, which is what I read on the internet are the wires needed for my modulating thermostat.

However I get the idea that I have the wrong wires. Earlier today I had the doors open for some maintenance men to do some work on my house and my radiators were burning even though I had the thermostat purposely set to as low as it could go to avoid using gas to heat the outside air.

Can anyone suggest fixes or tell me what I'm doing wrong? Thanks!

[Jake]

Hey Giftedbryan,

Sorry for the late reply. I wanted to follow up and ensure you are good to go. Please let me know if you are still having any trouble from here, as I would be happy to take a closer look and assist you further. 

Best regards,
Jake

[Giftedbryan]

Hi Jake,

Yeah I don't know what must've been the true issue, but I think switching the wires twice to check if I hadn't turned them the wrong way around must've reseated them to make a firmer connection.

I'm not sure if this community has such markers, but I'd put it as resolved if possible.

[Jake]

Hey Giftedbryan,

Glad to hear you were able to resolve the issue and everything is working properly. I will go ahead and lock the thread at this time, as this will mark the post as resolved. If you run into any questions, please feel free to reach back out and create a new post. Have a good one!

Best regards,

Jake