cancel
Showing results for 
Search instead for 
Did you mean: 
Replies are disabled for this topic. Start a new one or visit our Help Center.

Google nest continually needing reset

LizC1
Community Member

I have had Google nest for about 6 months. It was fine for a couple of months but now drops out at least every second day requiring reset. My internet is ‘blazing fast’. I am in a 3 story terrace with nests in lower 2 levels (I’m not bothered about the top level). I have 2 nests, one in the second level and one on the lower level and the base one that attaches to the modem is at the opposite end of the lower level to the nest down there. I have reset the entire nest with no discernible improvement. After reading previous complaints I am not optimistic about finding a solution. Can you recommend a wifi extender that will work seamlessly with Google nest without requiring complicated set up. I assume that will assist.  I use internet for TV and IOS and Microsoft products, if that’s relevant. 

1 REPLY 1

Dan_A
Community Specialist
Community Specialist

Hi LizC1,

 

That certainly isn’t the experience we want you to have, and we apologize for the delay. A few questions: are you using a modem/router combo from your Internet Service Provider (ISP)? Which Google/Nest router are we working with? What device are you using to set up your network (iOS or Android)? Do you have the Internet on your modem?
 

You can do a sequential reboot of your entire network and see if that helps, or please perform a 2-minute power cycle on your entire network to re-establish the connection on your connected devices. Here's how: 
 

  1. Disconnect the power from the modem.
  2. Disconnect the Ethernet cable and power cord from the parent point.
  3. Disconnect the power cord from the child points.
  4. Leave everything unplugged for 2 minutes.
  5. Connect the power cord to the modem then to your router and points.

 

Also, you can give these steps a try:

 

  1. If you're using a modem/router combo, set that to bridge mode to avoid double NAT issues.
  2. Make sure that there is minimal to no interference (concrete, bulletproof glass, metal, mirror, etc.) and the points are no more than two rooms apart.
  3. Remove any special characters in your network name and password.
  4. Turn off IPv6:
    1. Open the Google Home app.
    2. Tap the Wi-Fi coin  and then Settings.
    3. Scroll down and tap Advanced networking.
    4. Scroll down to IPv6.
    5. Toggle the switch off Toggle button off.
  5. Change your DNS server into 8.8.8.8 on the primary and 8.8.4.4 on the secondary server. Hit the save/ floppy disk icon on the upper right.
  6. Unplug the power from your Google Wifi devices for 2 minutes.
  7. If the issue persists, try factory resetting your network. Take note that this will delete all network data.

 

You may skip any step that you’ve done already.

 

Let us know how it goes.

 

Best,

Dan