12-08-2021 07:18 PM - edited 12-08-2021 07:21 PM
am I compatible with nest thermostat? if so, how can i connect wires to where? and how about c-wire?
W - white, B - Blue, Rc - Red, G - Green, O - Orange, Y - Yellow, Rc&Rh - jumper, no c-wire*
Answered! Go to the Recommended Answer.
12-08-2021 09:18 PM
yes your system is compatible, connect as follows:
- white as W1
- green aa G
- blue as C
- yellow as Y1
- orange as *OB
- red as R
Can you also please send me the make and model of your current thermostat? thanks
12-09-2021 04:51 AM - edited 12-09-2021 04:56 AM
Yes you should be able to use any of the Nest thermostats with your setup. Some connections on the Nest wire plate are named differently depending on the particular Nest model, for example there is no R for the Nest learning thermostat, but Rh and Rc, and you would plug into Rh. The rest should be the same for you.
12-08-2021 09:18 PM
yes your system is compatible, connect as follows:
- white as W1
- green aa G
- blue as C
- yellow as Y1
- orange as *OB
- red as R
Can you also please send me the make and model of your current thermostat? thanks
12-09-2021 03:23 AM
Oh thank you so much. Here’s more info on old thermostat: White rodgers - 1F78
12-09-2021 04:28 AM
Ok thanks. Just to make sure, you don’t have a heat pump in your hvac system, correct?
12-09-2021 04:46 AM
Not that i know of..i know i have a/c condenser outside.
12-09-2021 04:47 AM
You would know if you had one, it’s a very special setup.
12-09-2021 03:55 AM
And this configuration works with other nest model also, correct?
12-09-2021 04:51 AM - edited 12-09-2021 04:56 AM
Yes you should be able to use any of the Nest thermostats with your setup. Some connections on the Nest wire plate are named differently depending on the particular Nest model, for example there is no R for the Nest learning thermostat, but Rh and Rc, and you would plug into Rh. The rest should be the same for you.
05-22-2022 11:36 AM
What if I dont have an orange wire? I have
c, blue
g. Green
y. Yellow
w. White
rh. Red
jumper wire from rc to rh
07-06-2022 11:33 AM
Hello I had this setup and could not get nest to function
07-06-2022 11:39 AM
07-06-2022 11:40 AM
Original thermostat
07-06-2022 11:41 AM
Also red flashing on zone 1 on air handler in attic with nest installed
07-06-2022 11:45 AM
6 wire system, black and orange wires are not used, there was small jumper from rh to rc on original thermostat, from my understanding nest system does this automatically, not sure what issue was, went back to original thermostat and everything working now.
01-02-2023 06:37 PM
Hello. I need some help with setting up my Google Nest thermostat, please. I put all the wires as instructed but the heat pump does not start. The heat starts but the outside unit does not. When I switch back to the old one, everything starts. Can anyone help? I attached te old and the new wiring set up. Thanks
01-04-2023 12:17 PM
What about this one? It's a heat pump. I can't figure out what to do with the brown wire. It was manufactured 5/22 if that helps.
01-04-2023 12:20 PM
Current thermostat is Honeywell TH5220D
01-08-2023 10:11 AM
Hello folks,
Thanks for taking the time to let us know about your inquiries. I'd be happy to take a look into this.
@Mihai1, I see that you wired it correctly to your Nest Thermostat. To make sure it was properly configured, please try resetting the thermostat to default settings and make sure to choose the appropriate wires connected to its base during the set-up. Once finished, call for heat and cooling and keep us posted on how it goes.
@nickdonellan, To check your system's compatibility, could you also share a photo of your thermostat's wiring with us? I'll look forward to your response.
Regards,
Mark
01-08-2023 12:34 PM
I don't see how to add a picture to this thread
01-08-2023 12:35 PM
Here you go. This is my setup
01-08-2023 12:40 PM
here is a pic of my setup. I wasn't logged in. I see how to add the picture now. Oops
01-08-2023 01:04 PM
Hi nickdonellan,
Thank you for sharing the photo of your thermostat's wiring. It appears to be compatible with Nest Thermostats. If you have a heat pump system, the brown wire should go to the O/B terminal for the Nest.
Feel free to let us know if you have more questions in mind.
Regards,
Mark
01-09-2023 10:47 AM
I tried that already and when I turned it on "cool" the vents were blowing heat
01-09-2023 10:47 AM
what about the white wire
01-09-2023 10:54 AM
Hello there,
Great troubleshooting so far, @nickdonellan. I'm sorry, but the label is blocked by the wire. Could you confirm what's on the label behind it? Could you also share a photo of your Nest Thermostat's wiring with us? Also, I found an article with some troubleshooting steps; let us know if that helps.
Thanks,
Mark
01-10-2023 10:23 AM
I will write out a diagram when I get home from work and post it here. Thanks
01-10-2023 11:06 AM
Hi there,
No pressure! I appreciate your effort, @nickdonellan. I'll keep an eye on this.
Thanks,
Mark
01-10-2023 06:28 PM
Here you go. Thanks
01-10-2023 06:29 PM
01-10-2023 06:30 PM
01-11-2023 02:23 PM
Hi nickdonellan,
Thanks for sharing the diagram. Big help! Do you have a second-stage cooling system? If yes, the Nest Learning Thermostat 3rd Generation would be compatible with your system. Let us know if you have more questions in mind.
Mark,
Mark
01-12-2023 05:57 PM
I will try this weekend and let you know. I put the old one back because I was unable to diagnose the problem. I will keep you posted. Thank you for your time and expertise.
02-13-2023 12:28 PM
Hey there,
I wanted to check in and see if you managed to see Jenelyn's post. Please let me know if you have any questions from here. I would be happy to assist, and make sure you are good to go.
Best regards,
Jake
02-16-2023 11:18 AM
Hey there,
I wanted to check in, and let you know that I will be locking the thread in 24 hours.
Best regards,
Jake
01-12-2023 11:51 AM
I'm not sure what a second stage colony system is...
01-12-2023 11:51 AM
*cooling
01-12-2023 12:11 PM
I have a heat pump. Will that work?
01-12-2023 11:53 AM
So it's only going to work if I have a second stage cooling system? How can I check to see if I have that?
01-14-2023 10:40 AM
I finally figured it out. I had my heat pump o/b wire set to b bc the wire was brown. Changed it to "o" and now it finally works. I was sick the first time I tried to install it. Just didn't have the patience to troubleshoot it, I guess. Thanks for all your help!
01-19-2023 12:23 PM
Hello folks,
@nickdonellan, Thanks for posting and for keeping us in the loop on what you've done to have your concern rectified. If there’s anything else I can help you with, please let me know.
I appreciate your efforts, @Mihai1. Please keep us updated, and I'd appreciate hearing the outcome.
Regards,
Mark