Connecting Nest Power Connector to Taco Multi Zone Box

[spbelly]

Hi All,

I have a two nest thermostats that only have a red and white wires available. It would be very difficult to run a new wire with a C-wire to either of them due to their location. Instead I have ordered a pair of Nest Power Connectors. The thermostats are part of a multi-zone system that runs through a TACO multi zone box (see pic of box and wiring diagram). I can see where the 24V power is located on the board (upper left) but I am not sure if I can connect the power connector to that part of the board. Would the best thing be to run a single wire from that location on the board our of the box and then connect the C-wire of the two power connectors to that same wire? Any advice would be appreciated.

Taco 4 zone boxWiring diagram for box

[EdwardT]

Hi spbelly,

Thanks for reaching out. I'm sorry to hear that you're having an issue with installing your Nest Power Connector. If you haven't yet, please check this link to learn more about installing your Nest Power Connector.

Thanks,

Edward

[Jake]

Hey there,

I wanted to check in and see if you managed to see Edward's post. Please let me know if you have any questions from here. I would be happy to assist, and make sure you are good to go.

Best regards,
Jake

[EmersonB]

Hi folks,

@spbelly just one quick final check in here since activity has slowed down. We'll be locking the thread in the next 24 hours, but if you still need help, I would be happy to keep it open. If there's more we can do, just let me know.

I appreciate the help, Edward and Jake.

Regards,
Emerson

[spbelly]

Go ahead and shut down. I have come up with a different solution in the end (swapping to different model).

[Jhonleanmel]

Hi spbelly,

We're sad to see you go. We hope we can make it up to you in the future. Send us a message if you change your mind.

Best,

Mel

[Jake]

Hey there,

Per your request, I am going to go ahead and lock the thread at this time. If you have any questions from here, please feel free to create a new post.

Best regards,

Jake