Will this work with our new Bryant system ?

[Bagent]

Just got a new system and can't really match up the wires with the compatibility tool wire selections.

[Houptee]

Go to the system end and see where the wires connect is there a white control box with thermostat wires going to it? Take pics of it and the control board in the system look for the screw terminals on the board and take pics.

Then we can help you once we see the system end wiring.

That tstat you have looks like a proprietary one for bryant but if you take some pics if should be able to be replaced by removing the control module on the system end, and moving the wires directly to the correct terminals on the control board.

[Bagent]

We will look into it.  Thank you!

[Jake]

Hey Bagent,

I wanted to check in and see if you are still in need of any help with your device. Were you able to find, and take a picture of the wiring? Please let me know, as I would be happy to assist, and answer any questions you may have.

Thanks so much Houptee for the helpful reply.

Best regards,
Jake

[Bagent]

Yes, I did.  Thanks for the follow-up.  I am trying to insert it but I have a message saying that I do not have permission to upload images.

[aatienza]

Hey Bagent,

Oh no! I'm sorry to hear that. Are you using your phone to post images here? If so, try to close the browser and reboot your phone to see if that helps.

Thanks,

Archie

[Bagent]

I had to resize the photo so I moved it to my computer.  I resized using the snipping tool and saved it both as a png and a jpg and still got the message.  I also tried saving as pdf but got a message that that was an unacceptable format.  I think I'll just contact my HVAC guy but I really do appreciate all your help!

[aatienza]

Hey Bagent,

We understand — I'll keep this thread open and wait for your update.

Thanks,

Archie

[aatienza]

Hey there,

I just wanted to follow up to see if you still need our help. Please let us know as we would be happy to answer any questions you may have. 
 

Thanks,

Archie

[Bagent]

Since I can't upload the image, it's probably best if you just close the thread.  Thanks for the follow-up.  I really appreciate it.

[Jake]

Hey Bagent,

I wanted to check in and see if you managed to see Houptee's post. Were you able to figure out how to wire the device? Please let me know if you have any questions from here. I would be happy to assist, and make sure you are good to go.

Thank you so much Houptee for the helpful reply.

Best regards,
Jake

[Jake]

Hey Bagent,

I wanted to follow up with you, and see if you had any questions. Please let me know, as I would be happy to assist, and answer any you may have.

Best regards,

Jake

[Bagent]

Thanks for the follow-up Jake.  We contacted our HVAC installer and they are going to change out our thermostat.

[Markjosephp]

Hi Bagent,

Thanks for the update and letting us know that your thermostat will be replaced by your HVAC installer.

If there’s anything else we can help you with, please let us know as we'll be locking this thread in 24 hours.

Thanks,

Mark

[Houptee · Accepted solution]

That looks like a Honeywell thermostat that has a control box usually mounted near the furnace where they connect all the thermostat wires.  To use nest you have to remove the control box and connect the wires directly to the furnace control board terminals.