cancel
Showing results for 
Search instead for 
Did you mean: 
Replies are disabled for this topic. Start a new one or visit our Help Center.

replacement display wont connect

lukecranky
Community Member

Hi 

My wifi chip died in my thermastat screen and google sent me a replacement. But now the old one is just stuck in a constant restart loop. But when i try to connect the new one using replace heatlink option and inputting the code off the bottom of the heatlink it fails to connect. 

Any suggestions? please 

 

Luke 

1 Recommended Answer

Super_paulie
Community Member

i had a bit of an issue doing the same. In the end i reset the heatlink until it was pulsing the blue LED. Then when pairing the display i selected "Replacement heatlink" and then it asked for the code on the bottom of the existing heatlink. Then it worked first time.

View Recommended Answer in original post

2 REPLIES 2

Super_paulie
Community Member

i had a bit of an issue doing the same. In the end i reset the heatlink until it was pulsing the blue LED. Then when pairing the display i selected "Replacement heatlink" and then it asked for the code on the bottom of the existing heatlink. Then it worked first time.

lukecranky
Community Member

thanks.  It has now worked. I think the old thermastat was still connecting even though was stuck in a constant restart loop. Once i took that far out of range the new one connected 1st time. Ive only had the old one for 2 months hope its just a unlucky issue with a wifi chip going but seems pretty common fault.  

 

Cheers for you help Paulie.