cancel
Showing results for 
Search instead for 
Did you mean: 
Replies are disabled for this topic. Start a new one or visit our Help Center.

Heat permanently on ?

JRT750
Community Member

 Nest  appears to be working properly , however heat is signal is permanently. I had to disconnect white wire to stop furnace .  I did reset set nest twice but still same symptom. Even removing nest from base there is till have a closed heat circuit . 

2 REPLIES 2

laurentbourg
Bronze
Bronze

Is this a new install? Do you have a C wire?

Thank you for your response.......... There is no C wire ............This nest has been in use for a few years. Problem started with the furnace gas valve "Not" opening  upon start-up .Control  Board was changed in the furnace,    furnace fixed............. Now did the old  board somehow damage the nest?  In the base of the nest the circuit is still closed signaling for heat.   Does the nest have a  relay in its base that is stuck or burned closed?