Remove Nest Thermostat 3rd Generation from wall to paint

[mabrams25]

I have a perfectly functioning 3rd generation nest thermostat that i need to remove in order to paint. 

1. Do I need to shut  down the thermostat or flip the breaker before removing?

2. Will the thermostat retain its settings when I plug it back in?

Thanks!

[Patrick_Caezza]

@mabrams25 

The answer to all of your questions is Yes.

You need to turn the HVAC off at the breaker

The internal battery should retain its configuration for a week or so.

Be sure to take a picture of the current wiring for when you re-install it and tape up the ends and cable so they don't get paint on them. Be sure to isolate each wire and not short them

[mabrams25]

@Patrick_Caezza

Thanks very much!

[Markjosephp]

Hello folks,

I wanted to ensure that everything was covered here.
 

Thanks for your help here, @Patrick_Caezza.

@mabrams25, I hope you've found the answer you're looking for. If you're still in need of assistance, feel free to let us know.

Regards,

Mark

[Markjosephp]

Hi mabrams25,

I wanted to see if you still needed help. Please let us know if you have any other questions or concerns.

Thanks,

Mark

[Markjosephp]

Hello mabrams25,

It has been a few days since your last reply, and we're going to lock the thread within 24 hours. If you have any questions, please feel free to create a new post.

Regards,

Mark