Using the heat-cool mode: There are 2 temperatures (high and low)

[goldfinch]

In the heat-cool mode there are always 2 temperatures listed.  The high is in blue and the low is in orange.  I want the orange (low) temp to start at 10 pm.  How do I do that?

[Ivan275i]

Go to schedule, click on a day you want to set this and then on 10pm. That should add a blue/orange bar. Drag the blue and orange to the temperatures you want. Setting blue to say 70 and orange to 60 would mean your AC will turn on if the house it over 70 and the heater will turn on if the house if below 60. Don't set the blue and orange too close to each other or they may take turns heating and cooling the house. Same goes for multiple thermostats. I have seen the upstairs unit cooling to 70 and the downstairs heating to 68 and they would run all day fighting each other.

[goldfinch]

Thank you.  This is exactly what I needed to know.  It was not explained well in the original directions I received.

[EdwardT]

Hi folks,

@Ivan275i, thanks for the help!

@goldfinch, thanks for reaching out. Ia'm glad to hear that you got the information you need. Don't hesitate to reach out if you have other questions.

Thanks,

Edward

[EdwardT]

Hi goldfinch,

It's me again. I wanted to check back in to see if you have other questions and concerns. Feel free to let me know if you do. 

Thanks,

Edward

[MelbaDT]

Hi, 

We haven't heard from you in a while so we'll be locking this thread if there is no update within the day. If you have any new issues, updates or just a discussion topic, feel free to start a new thread in the community.

Best, 

Melba