03-12-2022 04:37 PM
I believe I have the power connectors correct, but they are not being detected when I go to settings on the Thermostat.
I can measure 25V at the thermostat.
does anyone know what the power measurements should be? One of mine show:
3.665V
VOC 33.69
VIN29.48
lin = 20 mA(i) <-- is this an issue?
03-12-2022 07:36 PM
You need to post a picture of how the original thermostat was wired and how you have wired the Nest products.
03-13-2022 06:40 AM
03-13-2022 06:51 AM
The two Grey wires (W and R) for the nest power connector are connected that are indicated in the first picture of my control panel. The C wire is connected to the 24V. The right side of the Next Power Connector (the white wire C and W) are connected as follows: C=T2 and W=A1
03-13-2022 10:39 PM
Is this for a multi-zone boiler system? What is the make and model number for it?
The "C" terminal is the common aka return for the 24VAC.
The thermostats for this system looks like they are just simple two-wire thermostat and they only provide a switch closer to the system.
I'm truly surprised that you haven't blown some fuses.
03-14-2022 09:03 AM
Yes, its a multi-zone boiler system. Make: System 2000 Energy Kinetics Mode: EK-1C.
Yes, I only have 2 wires for the thermostats.
No blown fuses yet! Thermostats function normally the way its connected in the pictures.
03-25-2022 01:01 PM
any more help here anyone?
12-21-2022 06:42 AM
Did you ever figure out how the power connector is attached to your energy kinetics without a error code?
01-03-2023 11:04 AM
Hi everyone,
energykinetics, sorry for the delay.
A quick question: what message are you getting on your Nest Learning Thermostat?
Best,
Mel
01-06-2023 01:25 PM
Hey there,
Checking back in should you still have some questions here. Let us know by replying to this thread.
Best,
Mel
01-06-2023 04:58 PM
N260 error code
01-10-2023 02:53 PM
Hey there,
I wanted to follow up and see if I could be of any help. If you are getting an N260 error, a C wire or Nest Power Connector is recommended for your thermostat. Please let me know if you have any questions from here, as I would be happy to take a closer look and assist you further.
Best regards,
Jake
01-13-2023 10:30 AM
Hey there,
I wanted to check in and see if you are still in need of any help. Please let me know, as I would be happy to assist, and answer any questions you may have.
Best regards,
Jake
01-16-2023 10:13 PM
Hello there,
Just checking in to make sure that you've seen our responses. Please let me know if you have other questions or concerns as I will be locking this in 24 hours if I won't hear back from you again. Feel free to start a new thread and we'll be happy to help.
I appreciate the help, Mel and Jake.
Thanks,
Archie