Nest Compatibility Check robertshaw 300

[yagobski]

I have not bought a nest yet can someone see if this will work? The compatibility checker said to upload a photo but i don’t know to where? 

[Patrick_Caezza]

RS2, RS1, and RSv+ are used for external indoor and outdoor sensors that the Nest Thermostats don't support and can be taped off.

The remaining wires will connect to the Nest thermostat by matching the labels.

[yagobski]

Thanks Patrick for the response but there is any problem if I switch to nest ? I am living in a very cold area (Montreal) and if I remove this wire maybe the system will not work as respected. 

[yagobski]

Anyone can help please?

[EdwardT]

Hi folks,

@Patrick_Caezza, thanks for the help!

@yagobski, thanks for reaching out. The Nest Thermostat already have a built in sensor for the indoor temperature and it uses the internet to know the outside temperature.

Thanks,

Edward

[EdwardT]

Hi yagobski,

It's me again. I wanted to check back in to see if you have other questions and concerns. Feel free to let me know if you do. 

Thanks,

Edward

[yagobski]

Thanks for the reply I already bought a nest and trying to install do you have a wire schema compatible with the photo I published please. Thanks

[MelbaDT]

Hey there, 

Just match the labels of your original thermostat wires to your Nest. Make sure to tape off RS2, RS1, and RSv+ as they won't be needed.

Best, 

Melba

[Princesss · Accepted solution]

Hi there,

Chiming in-- do you still need help with this? Let us know if you have additional questions, otherwise we’ll be locking the thread.
 

Best,

Princess

[yagobski]

fixed and installed thanks

[Princesss]

Hi yagobski,

Thanks for the update. Glad to know that it's already working. 

Since this has been resolved, I'll consider this as complete and will lock the thread in 24 hours. Feel free to start a new one if you need assistance with your Nest Thermostats and the community would gladly help.

Cheers,

Princess