09-13-2022 09:40 PM
I am trying to wire the power connector to my old Lennox G8D2-55-1 furnace. No c wire so using the transformer. The diagram from the advanced install download is a little generic. Wondering if someone has some insight. I'm attaching pictures of the wiring diagram and the inside of the furnace.
Thanks in advance
09-14-2022 06:39 AM
You need to be careful. You are dealing with line voltages. The transformer has two sides, the Primary and the secondary. You will need to ensure the secondary side needs to be approximately 24 Volts AC. The two wires of the secondary side would be the LINE and COMMON. The key is two keep them consistent. That is, the wire chosen for COMMON, is always COMMON. And, you need to find the one in your Lennox system that is used as the common and which is used as the LINE. Then use the Volt Ohm Meter and check the voltage of the secondary side.
09-20-2022 09:40 AM
Hey there Mikelatajka,
I'm just checking up on this thread, did you have any more questions or need any additional help?
Thank you for helping out on this thread, CoolingWizard!
Best regards,
Jeran
09-23-2022 10:57 AM
Hey there Mikelatajka,
Did you have any more questions or need any additional help?
Thank you,
Jeran
09-27-2022 11:54 AM
Hey there,
I wanted to check in with you, and let you know that I will be locking the thread in 24 hours.
Best regards,
Jake