Support changes to our earliest generation Nest Learning Thermostats Read more
Are you a homeowner and you are selling your home and leaving your Google Nest Thermostat for the new owner? What do you need to do to make the transfer painless for you and the new owner? First and foremost, DO NOT PERFORM A FACTORY RESET. The Googl...
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
Hi There,Could someone please confirm that my new HVAC system is compatible with Nest thermostats? Please see attached a picture of the existing wire config.Thanks,Matt
When a set to 75 cool it blows hot and starts heating up house instead cooling it
I have a 2020 Nest Thermostats and when I am trying to setup schedule, I notice that the schedule set point has to be 60 minutes intervals. Is there a way to change the interval between set point?
I just installed a new thermostat and I wanted to check to see if this was normal or what I need to do to fix it if it's not.I have forced hot air. When the thermostat turns the heat on, it runs for certain time, then it turns off. About 10-20sec lat...
I demand a new thermostaat GOOGLE . since i migrated more than a year ago from nest to google account it's not working anymore i have reset remove homes reinstalled everything this is very frustrating and i am gettingmore stressed when i see that use...
Hi All, I have dual zone heating & cooling system and using Nest Thermostats. I don't have C wire and bought Nest power connector. In the manual, It say that I need to wire Nest connector to zone control board but it doesn't say where in the board. S...
My thermostat is connected with wifi, but its losing connection with heat link device attached to the boiler. My boiler+heat link device is approximately 20mts away from thermostat. Is there any repeaters available to stabilise the connection?
My Google NEST is a bit away from the Heat link. Is there a device or repeater to link?
I have a GEN two thermostat. My battery was dead so I replaced it. It blinked red for a long time, but then eventually started blinking green. I can’t get past this. I googled and it said I was running into a start up error. Thermostat is non-functio...
User | Count |
---|---|
9 | |
8 | |
6 | |
6 | |
5 |