With hot water support, Google Home app now offers complete Nest Thermostat cont... Read more
Are you a homeowner and you are selling your home and leaving your Google Nest Thermostat for the new owner? What do you need to do to make the transfer painless for you and the new owner? First and foremost, DO NOT PERFORM A FACTORY RESET. The Googl...
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
I took off my old thermostat and found only 2 wires coming out of my wall, 1 green and 1 white. The green was connected to the B connector and the white connected to the W connector. A black wire was connected between the Rh and Rc connectors. Is my ...
Nest thermostat when trying to add my wife to the home: Can’t add a family member at this time. Retry. Then I have to let google have access to all of my contacts. Now I’m reading it is some setting in my G-Suite admin account?Have to have the google...
I am replacing 2 thermostat 1st floor and 2nd floor which controls each area. Installed the learning thermostat with no issue on 1st floor. Setup 2nd floor and thermostat could not be found and when trying to pair it showed thermostat rather than lea...
I haven't received a home report since Oct 2020. I have not changed any settings
I have a UNILUX fan coil HVAC system in my unit. I am interested in the Nest 3rd gen learning thermostat. Can I replace with a NEST?
I am unable to get enough power to my nest thermostat. I have forced hot air and cooling with multiple zones. I original had a 3 wire (R,W and Y). I ran another 2 wire with it to my furnace zone control board. I tried using one wire as the C Wire and...
How do I hook up multiple thermostats in the zone controller box? Do I need a separate power connector for each thermostat?
Keep getting the "remove the Nest from base and reattach it" message. I've confirmed wires are properly trimmed and inserted and are not bulging into back of device. What else should I try before I return it.
I have installed the T-stat and wired it to the HZ432. Heating works well. However, the two dampers in my system are not responding appropriately, resulting in on even heating. Any thoughts?
User | Count |
---|---|
13 | |
11 | |
11 | |
9 | |
9 |