Troubleshoot a W5 Code on Nest Thermostat Read more
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
HiOur Nest thermostat was working fine for the last 1.5 years. Suddenly, it started to connect to WiFi.we couldn’t access the nest app from phone for the last 2 months.we tried resetting multiple times. But, still having the same issue. Couldn’t do s...
So I have a hydronic radiant heat only system. T stats wire is 4 wire (r,w,o,b) but only r & w used with current dumb stats. I tried using the orange as a common by wiring it to the “c” connector on stat and the Com screw terminal on the taco relay s...
I am trying to add two nest thermostats to my nest app. I can add one, but then the second one fails to connect with a TD030 error. If I then remove the working device, I can add the second device perfectly, but then it can't connect the original wor...
During installation on Google Home App, keep getting compatibility message after identifying the six wires connected to the pins. This is a common wire 24volt system.
I had my Nest thermostat installed yesterday and it's saving me a fortune (had no thermostat installed at all).It was easy enough to set up and it's set up for Gas, Combi-boiler, radiators which is the system I have in the house.The nest app however ...
Hello, we have the learning thermostat with the room sensors. we have it to be as manual as possible. When we go to bed and set the sensor to the bedroom. The room sensor keeps changing back to the living room. Is there a way to stop this?
Thermostat is suddenly constantly offline. I have done the troubleshooting but still not working. Any ideas?
I cannot find a setting to manually turn off the heat pump so only the Aux heat runs. My “dumb” thermostat had a slider switch, and when moved to Aux heat, the outside heat pump would stay off and the inside coils would heat the house only. Looking f...
Is there an option to take all sensors and create an average temp that the system uses? This typically helps so there are not hot or cold spots. Worked very well in my old house with a Honeywell system. When looking into the nest product it doesn’t a...