With hot water support, Google Home app now offers complete Nest Thermostat cont... Read more
Are you a homeowner and you are selling your home and leaving your Google Nest Thermostat for the new owner? What do you need to do to make the transfer painless for you and the new owner? First and foremost, DO NOT PERFORM A FACTORY RESET. The Googl...
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
When in the heat mode the fan comes on but the condenser does not. The condenser runs when in the cooling mode but will not turn on in the heating mode. All wiring is in the correct location.
I have a Goodman heat pump in the attic with a Vivint thermostat that I am trying to connect my new Nest learning thermostat (3rd gen) to. I can walk through the heat pump setup using the Nest app but since my current thermostat has yellow & orange w...
I just installed a second nest learning thermostat upstairs. I am receiving an WiFi error message and it’s identified as Nest thermostat.
I keep getting emails saying the thermostat isn’t getting enough power. Says I need a C wire. Also keeps saying no wifi connection. Help!!!!
I have installed nest learning thermostat in living room, now i like to install nest thermostat in 2nd fl. But this thermostat only have 3 wires with jumper. ( no c-wire)W- white wireY - yellow wireRC - red wirejumper wire
Just installed a 3rd gen Nest thermostat and heat link. All wired up correctly and heating works fine when controlled be the thermostat but the hot water is constantly on but the thermostat says the hot water is off. Could anyone please help?it’s a s...
I installed the 3rd gen Learning Thermostat a few days ago and it's been a disaster. I set it to eco mode overnight (52F) but programmed it to 68F at 7 AM when I get up. I got up in a freezing house and the thermostat was in the eco mode still after ...
I get the error message E294:R is required. I checked the wiring connections and I have Red, Yellow, White and Green connected. What am I missing? Thank you
I have a free-standing 3rd gen learning thermostat (so it's not wired into the wall), it's powered by micro-usb connected into the back plate, serving 5V. It's connected to my Heat Link and there are no problems with that. My problem seems to be sole...
We are having trouble with the heater only blowing cold air out during the night but during the day hotWhy and how can we change that
| User | Count |
|---|---|
| 13 | |
| 12 | |
| 11 | |
| 10 | |
| 8 |