Are you a homeowner and you are selling your home and leaving your
Google Nest Thermostat for the new owner? What do you need to do to make
the transfer painless for you and the new owner? First and foremost, DO
NOT PERFORM A FACTORY RESET. The Googl...
Here are some steps I recommend to resolve issues during the setup of
Nest Thermostats.Before trying these stepsMake sure you're using the
correct app for setup. Need help checking which model you have? Use the
Google Home app to set up the following...
I have had a nest thermostat e for about four years, I installed it in
my previous apartment and just moved to a new unit in the same complex.
The past four years when heating it would only blow room temperature
air, but still heat the apartment just...
Hello,I have had a nest thermostat for 3 years & Today, the heat said it
was 100 degrees. ~30 degress off- I have factory reset-router
reset-restart-changed batteries-switched locations (from upstairs to
downstairs)Can someone help me here?
I have 2 heat pumps and 2 nests. One thermo works the other does not
turn off the heat and will automatically go into eco mode upon turning
off entirely. The other one operates normally. I paid a HVAC service to
diagnose my issues and check my units....
I have two Trane Gas Furnace / AC units and two Trane XL850 thermostats.
I also have a whole home humidifier on each of the systems that are
controlled by the Trane XL850 thermostats. The wires that are used are
D, R, B/C; can I use a Net Learning Th...
I have tried several times to install my new Nest thermostat today. I
can get it to work on the cool function but it does not recognize the W
wire. I checked the end of the wire and trimmed it for good measure but
it still is not detecting the wire.
On my existing thermostat I have three wires (white, green,red) and a
red jumper wire.The white and green wires are connected to the
corresponding W & G terminals.The red wire though is connected to the B
terminal though. When connecting to the Nest ...
Hello, I went onto the compatibility suite and it said my system was
compatible and after getting it looked online for advice on installing
my new thermostat. I was switching from a Danfoss TP4000 to nest for the
house, but wanted to keep zone two th...
