With hot water support, Google Home app now offers complete Nest Thermostat cont... Read more
Are you a homeowner and you are selling your home and leaving your Google Nest Thermostat for the new owner? What do you need to do to make the transfer painless for you and the new owner? First and foremost, DO NOT PERFORM A FACTORY RESET. The Googl...
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
I have recently installed a new boiler that came with the nest thermostat and I have downloaded the nest app. I have seen many tutorials about how to use the schedule to set daily heating but nowhere can I find info that shows how to schedule the hea...
When I set the desired thermostat temp much lower than measured temperature, the Nest is NOT in heat mode but heat will be blowing from the fancoil. For my condo fancoil the fan is always on as part of building circulation. The heat blowing when the ...
We just installed our new google nest e following all steps. We connected all wires where they should go and made sure it clicked. We turned on our power source and the thermostat is unresponsive. It’s not turning on, it’s not blinking lights. Not su...
I have a 1960's hot water radiator heat thermostate (honeywell Hg type) and a separate honeywell Hg type thermostat for the AC (1980's). How to connect them to one Nest Thermostat? The existing wiring are about 1 ft apart.
I am setting up Google nest thermostats. Followed the instructions, everything went well, thermostats is setup and connected to WiFi. While finishing up the setup on my iPhone (good home), had an error “Com.Google.sso error -206.” And google home app...
Hello, wondering if anyone could briefly explain why the W-wire worked instead of the Y-wire when I was installing the nest power connector following the heating and cooling instructions (instructions called for using the Y-wire). I have a gas furnac...
Hot air blowing when set to cool and cool air blowing when set to heat
I just installed a Learning Nest Thermometer to run my heat only base-board system. I do not have a c-wire for power so must rely on the built in battery. After initiating the device, I saw that it was “low battery”. I charged the unit for a couple o...
My AC frequently turns on and off several times over the course of about 10 seconds before it finally comes on and stays on. We've had the AC repairman out to our house several times over the summer trying to diagnose it, and he finally tried putting...
Not sure my system is compatible, with my Honeywell thermostat I had a jumper from W2 to Y2 and now when I set up the nest thermostat cause it heats when I ask for cool I believe I have a heat pump
User | Count |
---|---|
12 | |
9 | |
9 | |
8 | |
8 |