What is Nest Aware? Read more
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
Should be simple but isn’t..
My thermostat says wifi is connected but app says not connected.
Nest battery has slowly eroded over the last few years. It’s now at the point I have to remove from base and charge every few days. Nest talked me out of returning last year. Tried calling again and, of course, now it’s out of warranty!I also have th...
Hi, does anybody know if I can utilise a Nest Thermostat with a John Guest 8 zone wiring manifold ?Thanks in advance
3rd Gen Nest Learning - 2 stage Cooling - Does it display when active?See a couple of pictures below...I just switched from 2nd Gen (burnt out and died) to a 3rd Gen and wired it the exact same way.2nd Gen would say "2nd Stage Cooling" when it was tr...
Which wires go to which letters on the Nest thermostat? On the current HX3 thermostat in the picture it shows which wires go where, but when I try hooking it up to Nest I get an error saying no power is going to the R slot. Should the white wire (cur...
My HVAC system is a high end Goodman 2-stage A/C, only a few years old. It was professionally installed.I am very adept at electrical. I installed my NEST Thermostat myself in March of 2020. I added 3 temperature sensors so we could have it 'follow' ...
The old thermostat has the following: New Nest thermostat (3rd gen) brown -- W1/O/B to W1 black -- Y1 to Y1 green -- G to G red -- R to Rc blue -- C to C white -- W2 to W2/AuxLet me know if the above wiring scenario is correct.. Thanks
I'm trying to install a Nest Thermostat E on my old dual-fuel (propane) heat pump. I'm confused about the W wire. I understand that it's used by the thermostat to call for auxiliary heat (if the outside temperature is too low or the set-point is much...
My home is older and I have learned that my living room and my basement (where the furnace/AC is located) are connected via only 3 wires (cloth wrapped). Due to the nature of the construction, I cannot reasonably pull more wires or new conduit - I've...
User | Count |
---|---|
17 | |
16 | |
7 | |
6 | |
5 |