With hot water support, Google Home app now offers complete Nest Thermostat cont... Read more
Are you a homeowner and you are selling your home and leaving your Google Nest Thermostat for the new owner? What do you need to do to make the transfer painless for you and the new owner? First and foremost, DO NOT PERFORM A FACTORY RESET. The Googl...
Here are some steps I recommend to resolve issues during the setup of Nest Thermostats.Before trying these stepsMake sure you're using the correct app for setup. Need help checking which model you have? Use the Google Home app to set up the following...
I tried setting up nest thermostat from my old lennox icomfort Wi-Fi thermostat after setting it up the heating is not working. is it even possible to set up nest thermostat from Lennox icomfort Wi-Fi? Thermostat.
Hi Folks, I recently acquired a Nest thermostat to replace my existing Honeywell model #THX9421R02 that has two wires labeled R and C and when I connect the NEST unit using the connection labeled R and C I receive an error message stating that it nee...
Hey guys,My google nest was just installed today and I put my ac on and it started blowing hot air. Is this normal? If not, how do I fix it?
I have a nest thermostat and no c wire, but there are extra unused wires available. Can I simply get a plug-in transformer and attach it to the nest to give it the power it needs? Or is there more that I need to do to control the system? Thanks
So i was trying to install the nest power connector to solve the low battery issue on thermastat. There were 3 C terminals on the hvac board and i couldn’t figure out which one to connect c wire to. I am not an expert so i did capture the label of th...
Same as the subject. No X2 wire listed and no C wire either.
Hi thereWhen I first had Nest (and quickly realised that I should have bought Hive instead), I found an app which provided proper geolocation, which was desupported (some poor guy having realised that half the Nest user community was using his pet pr...
Need it replaced
I have a schedule set to COOL at night for sleep, and HEAT in the morning an hour before alarms.So, when I go to bed, the thermostat is on COOL. Even though there is a schedule set for HEAT in the morning, the heat never comes on. I have to manually ...
Here is a picture of the current Honeywell module on the furnace, I only have the R and W currently but I've run 2 sets of cabling, the 18/12 for the AC/heat pump and gas furnace and 18/5 for the whole home Humidifier. Anybody run across this setup b...
| User | Count |
|---|---|
| 12 | |
| 11 | |
| 8 | |
| 8 | |
| 7 |